Large tree stump ground in Rijswijk
I ground out a huge tree stump for a landscaping and construction company. The tree had already been cut down, but the stump was still there. With a large, thick, two-meter-long root that partly protruded above the ground. It was a tree next to an apartment building in Rijswijk. Because there was still a large piece of trunk sticking out above the earth, I first sawed it shorter. I always have large and small chainsaws with me.
Because I realized that the stump was 50cm wide, I brought my hand stump grinder with me. When we arrived on site, it turned out that the stump on the ground was one meter wide plus an enormous above-ground root. Such a large root requires just as much work as a decent-sized tree trunk. Actually too big for my hand stump grinder. But I started it anyway. Where there's a will, there's a way.
In order to remove the tree stump as quickly as possible, I first placed new chisels on the stump grinder. That makes a difference again. Chisels on a stump grinder wear out very quickly and therefore need to be replaced often. Sometimes they are already blunt after one stump. Like with this stump. Especially when rocks are hit.
Stones in the stump
While grinding the tree stump I hit large cobblestones several times. With the help of a large punching iron I was able to pry them loose and remove them. But the chisels of the stump grinder quickly become blunt when milling concrete or other harder stones. Especially because of the hard pebbles used in it. Bricks are less of a problem because they are a much softer material.
These cobblestones were in the tree stump. As you can see on the front cobblestone, it was hit by the chisels of the stump grinder. Oh dear! Bad luck for the chisels. They like wood, but are allergic to stone. That quickly makes them blunt. Just like a chainsaw quickly becomes dull from earth and sand.
A chisel from the hand stump grinder
The chisels of a stump cutter have a carbide cutting surface. This metal is called "widia" (from the German "Wie Diamant")
In this case I ground about 20cm deep. That's already pretty deep.
There is often more underground than you think.
Here you can clearly see that a root underground can be much larger than it appears.
These stones were in the tree stump.
The end result. The tree stump is gone.
Paving can now be laid where a tree stump used to be.
The tree stump is gone to about 20cm below ground level. Ready for laying paving or greenery.
Photos from this project