Oak felled and stumps ground in Apeldoorn

Tall oak felled in Apeldoorn

Tall oak felled in Apeldoorn

Apeldoorn. We removed a large oak tree and 3 tree stumps safely and carefully. The tree stood on the spot where a carport was going to be built. We also applied for and granted the felling permit. New planting was not required because there are already (too) many trees close together in this area. Thinning does no harm, it is only good, because it gives the adjacent trees more living space. The large tree stumps were quickly and comprehensively removed using a large tractor stump grinder.

First, the branches are removed from the tree using the most modern and safest climbing techniquess. In this case, the branches had to be captured with special capture rope, because very large branches were hanging above the house.

Catching (large) branches is a careful job, which we do not do in a hurry. We don't take any risks.

After removing the side branches, it is the turn of the top. This is also brought to the ground with ropes in a controlled manner, slowly but surely. If the trunk is short enough to drop, we cut the tree in such a way that the tree falls exactly in the desired direction. This can be done through the necessary experience. Because this tree was slightly inclined towards the house, felling wedges were continuously hammered into the saw cut during sawing, so that the tree (trunk) could not slant further. Once the cuts are completed, the tree is pulled around with a high rope. This is only necessary if it is necessary for the balance of the tree. If the balance of a tree is towards the desired direction of fall, then the assistance of a perimeter rope is not necessary. Don't try this at home! It takes experience.

Photos from this project

← Back to all projects

💬