tree pruning in Zwanenburg

Two beech trees pruned. A very pleasant collaboration with the customer. Customer found dragging branches "therapeutic". While I was sitting in the tree trying to remove much of the crown while maintaining its shape, the customer was dragging the ta

Two beech trees pruned. A very pleasant collaboration with the customer. Customer found dragging branches "therapeutic". While I sat in the tree to remove much of the crown while maintaining its shape, the customer dragged the branches to the front of the house where the trailer and chipper were located.

The customer was very happy with the result. It fully met his wish to reduce the crown volumes, while retaining shape, for more light in the house and more sun on the terrace.

I also applied maintenance pruning. Double and abrasive branches removed. Dead branches removed. And the tips were removed from all remaining twigs on the outside of the new crown, so that new twigs in the future will grow sideways instead of outwards.

The situation before pruning....

...and the situation after pruning. When a tree crown is significantly reduced due to overdue maintenance, the bare interior of the tree becomes visible. Many of the smaller outer branches are removed. This initially gives a bare appearance, but that will improve in the coming years. The tree will then need to be pruned every few years, with the tree becoming more beautiful with each pruning. More in the desired shape, and completely green again.

Preparations.

Busy in the tree.

Busy in the tree. narrowing and lowering the crown while retaining its shape.

A lot of pruning work can be done with a pole saw from the ground or from the roof of a shed. A lot of pruning work can also be done in the tree with the hand saw. Only the thicker branches are faster with the chainsaw.

Busy in the tree. In general, the higher you climb, the more control you have over the felling or pruning work. Because you can then saw off smaller pieces.

Photos from this project

← Back to all projects

💬