Beekbergen felling and milling diseased poplar

Sick poplar cut down

Sick poplar cut down

Watch on YouTube

In Beekbergen there was a poplar with many dead branches. Fungi could be seen on the trunk at the bottom. Fortunately, there were still some branches with leaves so that the tree was not completely rotten. I was therefore able to climb in to first remove some heavy branches. By first removing these branches, the center of gravity was moved in the desired direction. The tree could then be cut down at the bottom because there was enough space for the tree to fall in its entirety. Next to the tree was an old apple tree that had to be spared. While climbing, I therefore also removed the branch that would otherwise have collided with it when the tree fell.

Here I am with my leg in the tree. The inside was completely rotten. Hence all the dead branches in the tree.

The trap notch is good. Now I can start cutting the felling cut on the other side of the tree. Sapwood cuts on the side of the tree were not possible because the fracture strip was very narrow on the left and right due to the rotten inside of the tree. I therefore kept a wide break list and dropped the tree using wedges. Because I had already moved the center of gravity considerably to the desired direction, it went very well.

With our large stump grinder we ground out the tree stump to a depth of approximately 40cm. The intention is to build a shed on it in the future.

The tree stump grinder in action. He shreds the tree stump.

Watch on YouTube

Photos from this project

← Back to all projects

💬